RF4 4KC1 1080P 60FPS 4K HDMI USB Industrial Microscope Camera with Remote Control

RF4 4KC1 1080P 60FPS 4K HDMI USB Industrial Microscope Camera with Remote Control

Installation and Usage Steps:

1. Connect the microscope to the host computer using the C/CS interface and ensure it is securely tightened to prevent any accidental falls.
2. Connect the microscope to a monitor using the HDMI connection. Make sure the display supports a resolution of either 3840x2160 or 1920x1080.
3. Use the USB interface to connect the microscope to the computer for the UVC camera functionality.
4. Connect the power adapter to the host computer through the DC port.
5. If you intend to use the TF card for additional features such as taking photos, video recording, or playback, please insert it into the appropriate slot.
6. Switch on the power adapter, and observe the host indicator. It should display a green light for approximately 10 seconds.

Precautions for Customer Use:

1. Before taking photos or videos, make sure to insert a USB flash drive into the appropriate slot to store the captured data.
2. When the device is not in use, it is recommended to disconnect the power supply. This helps prolong the service life of the device and reduces unnecessary power consumption.
3. Ensure that the power adapter you use does not exceed the voltage limit specified for the device. Using a power adapter with higher voltage can damage the device.
4. Avoid any violent collisions or impacts with the microscope. Handle it with care to prevent damage to the device and its delicate components.