How to use POWER-Z USB PD Tester Voltage Current Type-C Meter KM001

2017-11-23
by Tony Coffey
How to use POWER-Z USB PD Tester Voltage Current Type-C Meter KM001

How to use POWER-Z USB PD Tester Voltage Current Type-C Meter KM001

POWER-Z USB tester QC3.0/PD Digital voltmeter amperimetro Digital voltage current amp volt Type-C meter power bank detector

Product Series: POWER-Z

Product Type: KM001

Product Name: Portable USB PD Tester

Operating voltage: 3.6-20V Current:3-5A

Support Agreement: USB PD, Qualcomm QC3.0 / 2.0, MTK PE / PE +, Huawei FCP / SCP, Apple 2.4A, BC1.2, DCP

Display voltage, current, power, mAh, mWh

Press the menu button can be transferred to the recording interface, you can set to store a variety of different capacity and energy data

Each stored data can be deleted and marked

Set the recording time interval and maximum capacity

Automatic run of the rule setting, current threshold setting

End time setting

Display the information interface

Test line resistance function

will be measured wire into the tester, followed by a load, the resistance will always beating, until the resistance is stable, the degree, is the size of the line resistance, and there are GOOD evaluation, let you know the wire is good Bad

You can set the waveform display refresh rate, the higher the refresh rate, the faster the display

Plug in the charger, the automatic display D + and D-voltage, the following shows the charger support the charging protocol

Press the menu button, automatically trigger quick charge voltage!

Press the menu button, automatically trigger quick charge voltage!

Press the menu button, automatically trigger quick charge voltage!



The purchase link: https://www.unionrepair.com/po...

Comments

No posts found

Write a review